MAINTENANCE LUBRICATING POINTS 1. Using a grease pump, pump in the grease through the grease fittings marked by the arrows. 2. After greasing, wipe off any old grease that was pushed out. Remark On jobsites where there is a lot of heavy-duty work, or on jobsites where operations are performed continuously for more than eight hours, grease the machine more frequently than prescribed. 1. Bucket pin (2 points) 2. Bucket link pin (2 points) 3. Dump cylinder pin (2 points) 4. Lift cylinder pin (4 points) 5. Lift arm pivot pin (2 points) 6. Tilt lever pin (1 point) 7. Steering cylinder pin (4 points) WA480-5L 3-49