MAINTENANCE EVERY 500 HOURS SERVICE Maintenance for every 50, 100 and 250 hours service should be performed at the same time. CHANGE THE ENGINE OIL, REPLACE THE ENGINE OIL FILTER CARTRIDGE The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. Refill capacity: 38 liters (10.04 US gal) Filter wrench 1. Open the engine side cover located on the right of machine. 2. Open the engine oil filler (F). 3. Loosen the drain plug (P), and drain the oil. 4. Check the drained oil.
If excessive metal particles or foreign material exist, please contact your Komatsu distributor. 5. Install drain plug (P). 6. Using a filter wrench, turn the filter cartridge (1) counterclockwise to remove it. 7. If this operation is carried out immediately after stopping the engine, a large amount of oil will come out. Therefore, wait for 10 minutes before starting the operation. 8. Clean the filter holder, fill a new filter cartridge with clean engine oil (or coat thinly with grease), then coat the seal and thread of the filter cartridge with engine oil. Install the filter. 9. When installing, bring the seal surface into contact with the filter holder, and tighten another 3/4 to 1 turn.
10. Run the engine at idle for a while, then stop the engine. Check that the oil level is between the H and L marks on the dipstick. For details, see “CHECK ENGINE OIL LEVEL, ADD OIL” on page 2-80. 3-50 WA480-5L