Komatsu — REPLACING FUEL FILTER CARTRIDGE

MAINTENANCE REPLACING FUEL FILTER CARTRIDGE Immediately after the engine is stopped, all parts are at high temperature, so do not replace the filter imme- diately. Wait for the engine to cool down before starting the operation. The inside of fuel piping system of the engine is under high-pressure when the engine is running. When replacing the filter, wait for at least 30 seconds after the engine stops to let the internal pressure go down before replacing the filter. Do not bring any fire or spark close. This engine consists of higher precision parts than on the conventional fuel injection pump and nozzle, so if dirt gets in, it will cause problems.

If there is any dirt stuck to the fuel line, use fuel to wash it off com- pletely. Always use a Komatsu genuine part for the fuel filter cartridge. If filters other than genuine filters are used, problems may occur in the injection system, so never use substitute parts. Be careful when opening the air bleed plug at the fuel filter head and the air bleeder of the supply pump. The system is still under pressure and fuel may spurt out. Container to catch the oil Filter wrench 1. Set the container to catch the fuel under the filter cartridge. 2. Using a filter wrench, turn the filter cartridge (1) counterclockwise to remove it. 3.

Clean the filter head, fill the new filter cartridge with clean fuel, coat the packing surface thinly with engine oil, and install it to the filter holder. Always use clean fuel when filling with fuel, and be careful not to let any dirt or dust get in. A. Add fuel from the small hole (A) (dirty side) at eight places. Do not add fuel from hole (B) (clean side) at the center. B. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it up 1/2 to 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to leakage of fuel.

If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. WA480-5L 3-51