Komatsu — CLEANING THE FUEL STRAINER

MAINTENANCE 4. After replacing the filter cartridge (1), loosen the air bleed plug (2). 5. Loosen the air bleeder (4) of the supply pump. 6. Pump priming pump (3) until no more bubbles come out with the fuel from air bleeder (4), then tighten the air bleeder (4). Tightening torque: 4.9 to 6.9 N·m (3.6 to 5.1 lb. ft.) 7. Continue pumping (about 50 times) until the priming pump (3) becomes stiff and the overflow valve release sound becomes con- tinuous. 8. Push the knob of priming pump (3) in and tighten it. 9. After replacing the filter cartridge, start the engine and check that there is no leakage of fuel from the filter seal surface.

If fuel leak- age exists, check the tightening of the filter cartridge. If fuel leak- age still exists, follow Step 1 and 2 to remove the filter cartridge. Check the packing surface for damage or foreign material. If any damage or foreign material is found in the packing, replace the car- tridge with a new part, repeat Steps 3 to 9 to install the filter cartridge. CLEANING THE FUEL STRAINER Immediately after stopping the engine, all parts are HOT. Wait for the parts to cool down before replacing the strainer. The engine fuel piping line is under high pressure when the engine is running.

When replacing the strainer, wait at least 30 seconds after stopping the engine to let the internal pressure go down before replacing the strainer. Never bring any flame close. This engine consists of higher precision parts than the conventional fuel injection pump and nozzle. If dirt gets in, it will cause problems. If there is any dirt stuck on or near the fuel line fittings, use Komatsu Safety Solvent and Degreaser to remove any dirt before loosening the fittings. Container to catch the fuel. Filter wrench 1. Set the container under the fuel strainer to catch the fuel. 3-52 WA480-5L