Komatsu — CLEANING THE FUEL STRAINER

2. Using the filter wrench, turn ring (1) to the left to loosen it, then remove element cup (2) and the element. 3. Wash the element and the inside of element cup (2) with clean fuel. 4. Clean the strainer head, fill the element cup with clean fuel, coat the packing surface thinly with engine oil, then install to the head, taking care not to damage the O-ring. Always use clean fuel when filling the element cup and be careful not to let any dirt or dust get in. 5. When installing, turn the ring (1) to the right to tighten it. Tightening torque: 23 to 27 N·m (16.9 to 19.9 lb. ft.). If the ring is loose, it will cause fuel leakage. Always tighten the ring to the specified torque. 6.

After installing element cup (2), bleed the air as follows. 7. Loosen air bleed plug (3) of the fuel filter. 8. Loosen the knob of priming pump (4), then pump it up and down until no more bubbles come out with the fuel from air bleed plug (3). 9. Tighten the air bleed plug (2). Tightening torque: 7.8 to 9.8 N·m (5.8 to 7.2 lb. ft.) 10. Push the priming pump knob (4) in and tighten it. MAINTENANCE WA480-5L 3-53