Komatsu — CHANGE TRANSMISSION OIL AND FILTER CARTRIDGE, CLEAN STRAINER

MAINTENANCE EVERY 1000 HOURS SERVICE Maintenance for every 50, 100, 250 and 500 hours service should be performed at the same time. CHANGE TRANSMISSION OIL AND FILTER CARTRIDGE, CLEAN STRAINER Immediately after stopping the engine, the parts and oil are HOT and may cause burns. Wait for the temper- ature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure. Remove the cap. Refill capacity: 54 liters (14.27 US gal) Filter wrench 1. Set a container to catch the oil under drain plug (P), then remove drain plug (P) and drain the oil. To prevent the oil from pouring out suddenly, loosen drain plug (P) and remove it gradually. 2.

After draining the oil, install drain plug (P). Tightening torque: 68.6 ± 9.8 N·m (50.6 ± 7.2 lb. ft.) 3. Set a container to catch the oil under the transmission filter. 4. Remove the drain plug (1) of the transmission filter, drain the oil, then tighten the plug again. 5. Using a filter wrench, turn filter cartridge (2) to the left to remove it. 6. Clean the filter holder, coat the seal surface and thread of the new filter cartridge with engine oil, then install it. 7. When the seal surface comes into contact with the filter holder, tighten another 2/5 turns with the filter wrench. 8. Remove the bolts (3), move the tube (4), and then remove the strainer (5). 9.

Remove any dirt stuck to the strainer (5), then wash it in clean die- sel fuel or flushing oil. If the strainer (5) is damaged, replace it with a new one. 10. Install the strainer (5) in the case. Replace the O-ring of tube (4) with a new part, then install the tube (4). 3-54 WA480-5L