Komatsu — CHANGE HYDRAULIC OIL, REPLACE HYDRAULIC OIL FILTER ELEMENT

8. Remove the mounting bolts (6) to the filter cover (5) at the top of the tank, then remove the cover. When the cover is removed, the force of spring (7) may make the cover fly off, so keep the cover pushed down when removing the bolts. 9. Remove the spring (7) and bypass valve (8), then remove element (9). 10. Check that there is no foreign material inside the tank, then clean it. 11. Install new element (9), then set bypass valve (8), spring (7), and cover (5) to the tank. If the O-ring of the cover is damaged or deteriorated, replace it. 12. When installing the cover bolts, push down the cover and tighten the bolts evenly. 13.

Add engine oil through oil filler port (F) to the specified level, then install cap. 14. Check the hydraulic oil is at the specified level. For details, see “CHECKING THE HYDRAULIC TANK OIL LEVEL AND ADDING OIL” on page 3-43. 15. Run the engine at low idle and extend and retract the steering, bucket, and lift arm cylinders 4 to 5 times. Be careful not to operate the cylinder to the end of its stroke (stop about 100 mm (3.9 in.) before the end of stroke. Remark If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder will damage the piston packing. MAINTENANCE 16.

Next, operate the steering, bucket, and lift arm cylinders to the end of their stroke 3 to 4 times, then stop the engine and loosen bleed plug (10) to bleed the air from the hydraulic tank. After bleeding the air, tighten plug (10) again. Run the engine at low idling when bleeding the air. 17. Check the hydraulic oil is at the specified level. For details, see “CHECKING THE HYDRAULIC TANK OIL LEVEL AND ADDING OIL” on page 3-43. 18. Next, increase the engine speed and repeat the procedure in Step 16 to bleed the air. Continue this operation until no more air comes out from plug (10). 19. After completing the air bleed operation, tighten the plug (10). Tightening torque:

11.3 ± 1.5 N·m (8.3 ± 1.1 lb. ft.) 20. Check that the hydraulic oil is at the specified level. For details, see “CHECKING THE HYDRAULIC TANK OIL LEVEL AND ADDING OIL” on page 3-43. 21. Check that there is no oil leakage from the filter cover mount. 3-58 WA480-5L