MAINTENANCE HYDRAULIC TANK VENT ELEMENT Immediately after stopping the engine, the parts and oil are HOT and may cause burns. Wait for the engine temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. 1. Before removing the breather, wipe off all the dirt from around the breather. 2. Remove the oil filler cap (F). 3. Remove the nut (2) of the breather (1); remove the cover (3). 4. Replace the filter element (4) with a new one. 5. Install the cover (3) and nut (2). 6. Tighten the oil filler cap (F). Remark It is possible to replace the element with the breather installed in the tank.
However, if the breather is removed, do not wrap the taper thread of the breather with seal tape when assembling again, and be careful not to tighten too much. WA480-5L 3-59