MAINTENANCE CHANGE THE AXLE OIL When changing the oil, apply the parking brake and secure the front and rear frames with the safety bar. Immediately after stopping the engine, the parts and oil are HOT and may cause burns. Wait for the temper- ature to go down before starting the operation. When the plug is removed, oil may spurt out. Therefore, turn the plug slowly to release the internal pres- sure, then remove the plug carefully. Refill the capacity (front and rear, each): 52 liters (13.74 US gal) 1. Set a container to catch the oil under drain plug (P). 2. Remove front and rear oil filler plugs (1), then remove drain plug (P) to drain the oil.
Remark Remove the mud and dirt from around the plug (1), then remove it. 3. After draining the oil, clean drain plug (P) and install it again. 4. Add axle oil through plug hole (1) at the specified level. Remark For axles with ASD (Antislip Differential), the brand of lubricating oil is different, so always use the specified lubricating oil. 5. After adding oil, check that the oil is at the specified level (1). For details, see “CHANGE THE AXLE OIL” on page 3-60. Remark For frequent brake use, change the axle oil at shorter inter- vals.
AIR CONDITIONER RECIRCULATION FILTER Remove both the recirculation air filter and fresh air filter in the same way as when cleaning, and replace them with new ones. For details of cleaning the recirculation air filter, see “AIR CONDITIONER RECIRCULATION FILTER” on page 3-60. To clean the element, see “CLEANING THE AIR CONDITIONER FRESH AIR FILTER ELEMENT” on page 3-44. 3-60 WA480-5L