Komatsu — CLEAN THE ENGINE VENT ELEMENT

MAINTENANCE CLEAN PPC CIRCUIT STRAINER Immediately after stopping the engine, the parts and oil are HOT and may cause burns. Wait for the temper- ature to go down before starting the operation. After removing the rubber hose, oil may spurt out. So turn the hose slowly to release the internal pressure gradually. Remove the hose carefully. 1. When rubber hose (1) and flange (2) are removed, oil will spill out, so set a container (capacity: about 300 cc) in position to catch the oil. 2. Remove rubber hose (1) and flange (2). 3. Remove strainer (3) and wash it in clean diesel oil. 4. Install strainer (3) in strainer case (4) from the concave side, then install with flange (2).

Remark Assemble with the protruding side (O-ring side) of the strainer at the front 5. Install the rubber hose (1). CLEAN THE ENGINE VENT ELEMENT Immediately after stopping the engine, the parts and oil are HOT and may cause serious burns. Wait for the temperature to go down before cleaning the engine breather. When using compressed air, there is a hazard that dirt may be blown up and cause serious injury. Always use safety glasses, dust mask, or other protective equipment. 1. Wipe away dust around the breather. 2. Loosen the clamp and remove the hose. Remove the breather (1). 3. Clean the breather body with light oil or cleaning oil. 4. Replace O-ring with new one.

Coat a new O-ring with engine oil, set it, then install breather (1). 5. Check the breather hose and pipe. If caked oil (sludge) adheres to the insides, replace the hose and pipe with new ones. WA480-5L 3-61