Komatsu — CHECKING BRAKE DISC WEAR

MAINTENANCE CHECKING BRAKE DISC WEAR When checking the brake disc for wear, apply the parking brake and secure the front and rear frames with the safety bar. Make sure that the brake oil temperature is less than 60° C (140° F) before checking the brake wear. If the disc is near the wear limit, perform inspection at shorter intervals, regardless of the specified inspec- tion interval. Check the brake disc for wear at four locations: front axle, rear axle, left, and right. 1. Remove the cap nut (1). 2. Depress the brake pedal, keep it depressed, and push in the rod (2) of the gauge until contacts the piston. 3.

The wear is the amount that the end face of rod (2) is protruding from the end face of guide (3). Measure the amount of protrusion. The point where the rod groove is level with the end face of the guide is the permissible limit for the disc wear. If the wear has reached this point, please ask your Komatsu distributor for inspec- tion and replacement parts. If the disc is near the wear limit, per- form inspection at shorter intervals, regardless of the specified inspection interval. 4. Install the cap nut (1). Tightening torque: 29.4 to 39.2 N·m (21.7 to 28.9 lb.

ft.) Remark On new machines, the position of the guide is adjusted so that the end face of the rod (2) comes to the end face of the guide (3). For this reason, do not loosen the locknut (4), except when replacing the disc.Perform the operation with two workers: one worker depresses the brake pedal and the other worker pushes the rod (2) in. WA480-5L 3-63