Komatsu — TOTAL LOAD DATA DISPLAY

OPTIONS, ATTACHMENTS 13. This action completes the setting of the remain mode. The character display returns to the normal service meter and time display. Once the setting has been made, even if the starting switch is turned OFF and operations are stopped, the setting is retained. When operations are started again, there is no need to perform the setting again. All further loads will be subtracted from the total load recorded before operations were stopped. TOTAL LOAD DATA DISPLAY 1. Check that the normal service meter and time are displayed on the character display. 2. Press the ( ‘ ) of monitor panel selector switch 1 and display “LOAD METER”. 3.

Press the ( ‘ ) of monitor panel selector switch 1, then press the (>) or ( 4. Press the ( ‘ ) of monitor panel selector switch 1 to display “TOTAL DATA”. The time when the load on the bottom line was calculated is displayed as the hour meter standard. 5. Press the (>) or ( select the data for each of A to E or the all lighted-up display. The total load data for each of A to E and for all data is displayed on the load meter display. Check the material selection display on load meter display (1). In the example on the right, all of A to E for all data selected light up. On display (2) the total load data for all data or individual total load data for A to E is displayed.

On display (3) the individual number of loads for A to E is displayed. 5-10 WA480-5L