OPTIONS, ATTACHMENTS CLEANING RADIATOR AND COOLER FINS Never open the engine side cover when the engine is running. Stop the engine completely before starting the cleaning operation. If compressed air, pressurized water, or steam hits your body directly, or causes dirt to fly, it may lead to personal injury. Always wear safety glasses, dust mask, or other protective equipment. Perform this procedure if there is any trash or paper stuck to the radiator. Remark When rotating the fan in reverse, be careful of flying dust and take steps to prevent cloth or other objects from getting caught in the fan.
In waste handling locations where trash accumulates on to the radiator or cooler, rotate the fan in the reverse direction and blow out any trash stuck to the radiator or cooler. This can be used to extend the cleaning interval. Method Of Rotating The Fan In Reverse 1. Set cooling fan AUTO/MANUAL switch (2) to MANUAL mode. 2. Set cooling fan FORWARD/REVERSE switch (3) to REVERSE mode. 3. Check to be sure the cooling fan reverse rotation pilot lamp (4) is blinking. Remark When the fan is running in reverse, the pilot lamp on the fan control box lights up. For normal operations, always use the fan rotating in the normal direction (forward). 4.
Run the engine at high idle, (at or above 1800 RPM) to get fan rotating full speed. 5. After completing the cleaning, run the engine at low idle for approximately 10 seconds. 6. If manual cleaning is to follow, turn the ignition switch to the “OFF” position and stop the engine. 7. Set cooling fan AUTO/MANUAL switch (2) to AUTO mode. 8. Set cooling fan FORWARD/REVERSE switch (3) to FORWARD mode. 5-30 WA480-5L