This feature is not used on Waste Handler applications OPERATION IGNITION SWITCH This switch (1) is used to start or stop the engine. position It is possible to insert and remove the ignition switch key, all the electric system switches are turned off, and the engine stops. In addition, the parking brake is automatically applied. position Electric current flows in the charging circuit, lamp circuit, and accessory circuit. Keep the ignition switch key at the “ON” position while the engine is running. “START” position This is the position to start the engine. Hold the key at this position while cranking. Release the key immediately after the engine has been started.
The key will return to the “ON” position when released. POWER MODE SELECTOR SWITCH This switch (2) can be used to switch the engine output to match the purpose of the operation. When the POWER mode is selected, the output mode pilot lamp (POWER mode) on the machine monitor lights up. NORMAL position: Normal mode (low engine output), operations where emphasis is on fuel consumption, such as operations on flat ground where high engine output is not needed. POWER position: Power mode (high engine output), operations where emphasis is on production. Remark For efficient fuel consumption, use the NORMAL mode.
The maximum engine speed is set lower than in the POWER mode, except for hard operations such as heavy- duty digging of rock. Ample power and low fuel consumption can be obtained in the NORMAL mode. Further- more, by pressing the accelerator pedal lightly, it is possible to reduce fuel consumption. Use the POWER mode when performing heavy-duty digging operations of rock or operations where speed is required, or when traveling at speed under the machine's own power on flat ground or on slopes. WA480-5L 2-33