Komatsu — TRANSMISSION CUT-OFF SWITCH

OPERATION TRANSMISSION MODE SELECTOR SWITCH This switch (3) is used to change the shift point when the AUTO SHIFT/MANUAL selector switch has been switched to auto shift. At each of the L, M, and H positions, the system switches to auto shift and the auto shift pilot lamp on the machine monitor lights up. Normally, set to auto shift. MANUAL position: System is set to manual shift and speed range is position selected by gearshift lever L position: Travel speed when shifting up is low (flat ground, normal travel) M position: Travel speed when shifting up is medium (traveling uphill, traveling at high speed) H position :

Travel speed when shifting up is high (traveling uphill, traveling at high speed) Remark For details of the manual shift, see “Manual Shift” on page 2-60. For details of the auto-shift, see “AUTOMATIC SHIFT” on page 2-61. TRANSMISSION CUT-OFF SWITCH When moving the machine on an uphill slope, set the transmission cut-off switch to the “OFF” position, depress the accelerator pedal while keeping the left brake pedal depressed, then gradually release the brake pedal and allow the machine to move. This way the machine can be prevented from traveling backwards. When the switch is pressed, the pilot lamp lights up and the system is turned “ON”.

The transmission is shifted to neutral at the adjusted brake depression position. Normally, keep the switch at the “ON” position. Turn this switch (4) and “ OFF”. For details of the method of adjusting the cut-off position, “ADJUSTING THE TRANSMISSION CUT-OFF” on page 2-98. Position (a): OFF The left brake pedal acts in the same way as the normal brake (right brake pedal). Position (b): ON The left brake pedal acts in the same way as the normal brake, and at the same time, sets the transmission to neutral. Remark The brake pedal position can be adjusted when the system is actuated with the transmission cut-off set switch on the right switch panel. 2-34 WA480-5L