Komatsu — 20.3 COOLANT SPECIFICATIONS

MAINTENANCE The following table shows the approximate percentage of antifreeze solution required for various temperatures. In tropical climates where antifreeze availability may be limited, use a corrosion inhibitor DCA4, to protect the engine cooling system. Inhibitors/Conditioners 1. All cooling system inhibitors, including those in antifreeze solutions, become depleted through normal operation. If the inhibitors in antifreeze are allowed to become depleted, the antifreeze becomes corrosive and attacks and coats the metallic surfaces of the cooling system which reduces heat transfer.Cooling system conditioners which contain these inhibitors must be added to maintain corrosion protection.

2. SOLUBLE OIL IS NOT RECOMMENDED for use in this engine as its use will reduce heat transfer. 3. There are no miracle additives that will increase heat transfer or prevent overheating. Conditioned water is still the best coolant. 4. DCA4 is recommended to inhibit corrosion in the cooling system for the following reasons: ! Improved compatibility with high silicate antifreezes to minimize hydro-gel formation if over concentration occurs. ! Provides engine protection in the following areas:

- Solder corrosion/bloom - Copper corrosion/erosion/stress cracking - Oil fouling - Cylinder liner cavitation corrosion - Aluminum cavitation corrosion - Seal and gasket degradation MAINTENANCE OF COOLING SYSTEM INHIBITORS Keeping the engine coolant properly inhibited will keep the engine and radiator free of rust, scale deposits and corrosion. New machines are delivered with antifreeze protection. Service at regular scheduled intervals specified in "23. MAINTENANCE SCHEDULE CHART" with a "service" DCA4 filter. Each time the coolant is drained and replaced, the coolant must be recharged with DCA4.

New coolant can be correctly charged with supplemental coolant additives by using DCA4 filters or DCA4 concentrate listed in the table entitled, "DCA4 Unit Guide". If coolant is added between drain intervals, additional DCA4 will be required. 3-14 Approximate Freezing Point Percentage of Antifreeze Concentration by Volume Specific Gravity at 16EC (60EF) 0EC (+32EF) -7EC (+20EF) -12EC (+10EF) -18EC (0EF) -23EC (-10EF) -29EC (-20EF) -34EC (-30EF) -40EC (-40EF) -46EC (-50EF) -51EC (-60EF) -57EC (-70EF) -62EC (-80EF) -68EC (-90EF) -69EC (-92EF) 0 15 25 33 40 45 48 53 56 59 62 65 67 68 1.000 1.025 1.040 1.053 1.062 1.070 1.074 1.080 1.083 1.088 1.092 1.095 1.097 1.098