MAINTENANCE 24.7 EVERY 500 HOURS SERVICE Maintenance for every 50, 100 and 250 hours should be carried out at the same time. 24.7.1 REPLACE FUEL FILTERS WARNING ! Engine ia at a high temperature immediately after the machine has been operated. Wait for the machine to cool down before replacing the filter. ! Do not bring fire or sparks near the filters. GENERAL The fuel filters are spin-on type filters. These filters cannot be cleaned and should not be disturbed except when it becomes necessary to replace them. Change the fuel filters as listed on the SCHEDULED MAINTENANCE GUIDE or sooner if a power loss is evident. If a power loss persists, consult your distributor. NOTE:
Fuel with more than the average impurities may require changing filters at shorter intervals. There are two fuel filters (1) located on the right side of the machine. Be careful not to allow dirt, water or other foreign material to get in the new filters. Keep new filters in the original package until ready for installation. REPLACEMENT 1. Open the engine hood and lock into position. 2. Clean the area around the fuel filters. 3. Using a filter wrench, remove the fuel filters by turning them counterclockwise. Discard the filters in a suitable manner. 4. Clean the filter gasket surfaces of the filter header for each filter. Replace the filter O-rings. 3-52