MAINTENANCE 5. Fill the new filters with clean diesel fuel. Then, apply a thin coat of clean engine oil to the seal of the filter. 6. Install the filters on the filter header until the filter seal contacts the seal surface of the filter header and then, turn the filter an additional 1/2 to 3/4 turn by hand. Do not over tighten the filter or damage may result to the filter seal or threads. Use genuine filters. 7. After replacing the filters, start the engine and idle it for a few minutes. Check the filters for possible fuel leakage. 8. Close the engine hood. NOTE: Controlled venting is provided at the injection pump through the fuel drain manifold.
Small amounts of air introduced by changing the filters or injection pump supply line will be vented automatically, if the fuel filter is changed in accordance with the instructions. However, manual bleeding will be required if: ! The fuel filter is not filled prior to installation. ! The injection pump is replaced. ! High pressure fuel lines are replaced. 3-53