Komatsu — 24.9.1 COOLING SYSTEM, REPLACE COOLANT AND FLUSH THE SYSTEM

MAINTENANCE 24.8.8 CHECK TIGHTENING PARTS OF TURBOCHARGER Contact your Komatsu distributor to have tightening portions checked. 24.8.9 CHECK PLAY OF TURBOCHARGER ROTOR Contact your Komatsu distributor to check the play of the turbocharger rotor. 24.9 EVERY 2000 HOURS SERVICE Maintenance for every 50, 100, 250, 500 and 1000 hours should be carried out at the same time. 24.9.1 COOLING SYSTEM, REPLACE COOLANT AND FLUSH THE SYSTEM WARNING ! If the engine was just running, then the coolant could be hot and cause personal injury. Allow the engine to cool before draining water. ! Never remove the radiator cap when the engine is at operating temperature.

At operating temperature, the coolant is under pressure. Steam blowing up from the radiator could cause personal injury. Allow the engine to cool until the radiator filler cap is cool enough to touch with your hand. Remove the filler cap slowly to allow pressure to be relieved. ! Never go under the vehicle while the engine I running, since cleaning is preformed while the engine is running, it is very dangereous to go under the machine in case the vehicle starts moving. GENERAL The cooling system operates under pressure which is controlled by the pressure relief valve in the radiator cap.

The belt-driven water pump circulates the coolant through the engine block, cylinder heads, radiator and engine oil cooler. Circulation is controlled by the thermostat which by-passes coolant flow around the radiator until the engine reaches operating temperature. Proper cooling is possible only when the system is sealed, the radiator cap gasket is in good condition, the pressure relief valve and thermostats are operating properly. The system is free of coolant and air flow restrictions and the system is filled to the proper level. Selection and maintenance of the engine coolant is important to long engine life.

The following information provides recommendations for selecting the engine coolant, maintaining the coolant inhibitors and servicing the cooling system. The system operates successfully with a water/antifreeze mixture or inhibited/conditioned water as the coolant. Water alone allows rust, scale deposits, and corrosion to occur within the system. After 2,000 hours or 1 year of operation, whichever comes first, the cooling system should be drained, flushed, and refilled. For complete coolant specifications see "20.3 COOLANT SPECIFICATIONS". 3-62