Komatsu — 24.8.7 CHECK FAN BELT TENSIONER BEARING & FAN HUB BEARING & INSPECT FAN BELT

MAINTENANCE 24.8.6 CHECK FAN BELT TENSION 1 Measure the belt deflection at the longest span of the belt when pressed with the finger. Maximum deflection: 9.5 - 12.7 mm (3/8 to 1/2 in) NOTE: Cummins belt tension gauge ST-1293 may be used. The required gauge value is 267 to 578 N (60 to 130 lbf). 24.8.7 CHECK FAN BELT TENSIONER BEARING & FAN HUB BEARING & INSPECT FAN BELT 1 Remove drive belt and complete the following steps: 2 Inspect the belt for damage. 3 Check the tensioner bearing. NOTE: The tensioner pulley should spin freely with no rough spots detected under hand pressure. 4 Check the fan hub bearing. Ъ The fan hub should spin freely without excessive end play.

5 Inspect the belt for damage Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with Transverse cracks are not acceptable. Replace the belt if is has unacceptable cracks, is frayed or has pieces of material missing. 6 Install the fan belt 3-61