MAINTENANCE 6. Refill the system with water only. 7. Then run the engine at low idle and open the drain valve (described in step 3.). 8. While the engine is running continue adding water in the top of the radiator, so that you are passing water through the cooling system for about 10 minutes. 9. After flushing the system with water then close the drain valve. 10. Now clean the system with a flushing agent. For details of cleaning see instructions given with the cleaning agent. NOTE: If the system shows mineral build-up, scale rust or oil, use a heavy duty radiator cleaner. NOTE: Do not use a caustic cleaners in the cooling system. Aluminum components will be damaged. 11.
After cleaning with the flushing agent, refill the system with fresh water and repeat step 7. and 8. and run until clean water comes out the drain valve. 12. Now turn the engine OFF, drain all the water out, then close the drain valve. WARNING Antifreeze is flammable, so keep it away from any flame. 13. Prepare the proper coolant for your environment as specified see "20.3 COOLANT SPECIFICATIONS". 14. Fill the system with the new coolant, leave the radiator cap off and run the engine for 5 minutes at low idle and then for 5 minutes at high idle to eliminate any trapped air in the system 15. Turn the engine OFF and wait 3 minutes then add more coolant until the radiator is full. 16.
Repeat step 14 and 15 until your sure all trapped air has been eliminated. 17. Drain and clean the inside of the radiator overflow tank (1) Then add coolant up to the FULL mark. 18. Install the radiator cap as outlined in this section. 3-64