MAINTENANCE 24.9.2 REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING ! The oil is hot if the machine has just been operated. Wait for the oil to cool down before changing it. ! When removing the oil filler cap turn it slowly to release the internal pressure, then remove it carefully. 1 Loosen bolt (1) at the top of the cap. 2 Remove the cap, then take out the element. 3 Coat the O-ring of the new element with grease, then install the element. 4 Align the cap with the body and tighten the bolts. 24.9.3 CHANGE AXLE OIL WARNING The oil is hot if the machine has just been operated. Wait for the oil to cool down before changing it. 1. Set a container to catch the oil under drain plug (P). 2.
Remove front and rear oil filler plugs (1), then remove drain plug (P) to drain the oil. 3. After draining the oil, clean drain plug (P), then install it. 4. Add axle oil throug plug hole (1) to the specfied level For details of the oil to use and refill capacity see "20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. To be sure that the oil is at the specified level, see "24.2.3 WHEN REQUIRED". REMARKS: For operations where the brake is used frequently, change the axle oil at shorter intervals. 3-65