MAINTENANCE 24.9.9 ADJUST ENGINE VALVE LASH CLEARANCE 1 15 mm wrench Remove the valve cover 2 Ѕ inch drive, engine barring cover Locate Top Dead Center (TDC) for Cylinder Number 1 by barring engine slowly while pressing on the engine timing pin. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a Ѕ inch ratchet or breaker bar. 3 When the pin engages the hole in the camshaft gear, Cylinder Number 1 is at TDC on the compression stroke. WARNING To prevent damage to the engine or pin, be sure to disengage the pin after locating TDC. 4 Feeler Gauge Intake Clearance: 0.254 mm (0.010 IN) Exhaust Clearance:
0.508 mm (0.020 IN) Check and set valves with engine cold - below 60 E C (1400 E F). NOTE: The clearance is correct when some resistance is "felt" when the feeler gauge is slipped between the valve stem and the rocker lever. 3-67