Komatsu — Komatsu PC290NLC-6K and PC290LC-6K Hydraulic Excavator Operation & Maintenance Manual

24. SERVICE PROCEDURE 24.2.6 REPLACE BUCKET SIDE CUTTERS WARNING It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable con- dition, then stop the engine and apply the locks securely to the levers. 1. Untighten nuts e and bolts c and remove side cutters a and b . 2. Clean cutter mounting face on bucket side plate. 3. Check nuts and bolts and replace if damaged. 4. Fit new side cutters. 5. Tighten bolts to 110 ± 10 kgm. NOTICE When side cutters are not being used shrouds f should be fitted to prevent wear of the bucket side plate. PC290-ENG 3-40