24. SERVICE PROCEDURE 24.2.7 REPLACE BUCKET TEETH Replace the point before the adapter starts to wear. 1. Set a block at the bottom face of the bucket so that is is possible to knock out the pin of tooth a , then check that the work equipment is in a stable condition, and lock the safety lock lever. Set so that the bottom face of the bucket is hoizontal. 2. Use a hammer and drift to knock out lock pin b . 3. After removing lock pin b , check for any damage and replace if nec- essary. 4. Clean the surface of adapter c and remove the soil from it with a knife. 5. Check the plug d for damaged rubber and replace if necessary. In- stall plug as shown, ensuring it seats correctly.
TOOTH SIZE MAX ALLOWABLE DEPTH 27-37 3.2 mm 6. Clean the inside of point a , then install it to adapter c . If there is mud stuck to it or if there are protrusions, the point will not enter the adapter properly, and there will not be proper contact at the mating portion. 7. Fit tooth with a 1/4 turn. Ensure plug remains fully seated. 8. Inspect the pin for damage and replace if necessary. Insert the pin as shown with the bevel down and the recess facing inside. Drive the pin until the plug engages the pin recess. PC290-ENG 3-41 WARNING It is dangerous if the work equipment moves by mistake when the teeth are being replaced.
Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers.