11. EXPLANATION OF COMPONENTS When breaker is installed When the front part of the pedal is depressed, the breaker is actu- ated. Set the working mode to the breaker (B.O). When general attachment is installed When the pedal is depressed, the attachment is actuated. The right hand switch panel has a ten position thumb-wheelswitch. This allows nine values of flow for the right hand foot pedal and no flow at position zero. When selecting switch positions, the RH foot pedal must be fully released before beginning work at the new flow setting. Please note your prefered switch position against attacment used for your future reference. PC290-ENG Adjustment of these range of flows is possible.
Contact your Komatsu dealer if required. 2-23 5. ATTACHMENT CONTROL PEDAL WARNING Do not put your foot on the pedal except when operating the pedal. If resting your foot on the pedal during operation, and it is depressed by accident, by accident the attachment may move suddenly and cause serious damage or injury. Do not put your foot on the pedal except when operating the pedal. If resting your foot on the pedal during operation, and it is depressed by accident, by accident the attachment may move suddenly and cause serious damage or injury. Switch Position 1 2 3 4 5 6 7 8 9 Approximate Maximum Flow (L/min) 30 50 100 125 150 170 202 280 Full Flow Attachment