12. OPERATION 5. Carry out bucket and arm operation for 5 minutes at full stroke, alternat- ing between bucket operation and arm operation at 30 second intervals. If the swing lock switch n is set to the ON (actuated) position and swing control lever b is operated at full stroke, oil temperature rise can be increased earlier. NOTICE When the work equipment is retracted, take care that it does not interfere with the machine body or ground. 6. After carrying out the warming-up operation, check that each gauge and monitor lamp is in the following condition. Engine water temperature gauge g : Inside green range Fuel gauge h : Inside green range Engine water temperature monitor i :
OUT Radiator water level monitor j : OUT Engine oil pressure monitor k : OUT Charge level monitor l : OUT Fuel level monitor m : OUT Air cleaner clogging monitor n : OUT Engine pre-heating monitor o : OUT Engine oil level monitor p : OUT Hydraulic oil level monitor q : OUT h g j i m q o p BP00100 k l n 7. Check that there is no abnormal exhaust gas colour, noise, or vibra- tion. If any abnormality is found, repair it. 8. Press working mode switch b on the monitor panel until the lamp of the mode to be used lights up.
H/O G/O F/O L/O B/O 12.3.2 IN COLD AREAS (AUTOMATIC WARMING-UP OPERATION) When starting the engine in cold areas, carry out the automatic warming-up operation after starting the engine. When the engine is started, if the engine water temperature is low (below 30 o C (86 o F)), the warming-up operation is carried out automatically. The automatic warming-up operation is cancelled if the engine water temperature reaches the specified temperature (30 o C (86 o F)) or if the warming-up operation is continued for 10 minutes. If the engine water temperature or hydraulic oil temperature are low after the automatic warming-up operation, warm the engine up further as follows.
NOTICE When the hydraulic oil is at a low temperature, do not carry out operations or move the levers suddenly. Always carry out the warming-up operation. This will help to extend the machine life. Do not suddenly accelerate the engine before the warming-up operation is completed. Do not run the engine at low idling or high idling continuously for more than 20 minutes. This will cause leakage of oil from the turbocharger oil supply piping. If it is necessary to run the en- gine at idling, apply a load from time to time or run the engine at a mid-range speed. 1. Set fuel control dial a at the low idling (MIN) position and run the engine for about 5 minutes without load. PC290-ENG 2-54