ASSEMBLING INSTALLING BOOM WARNING: Never allow anyone to enter into the area under a lifted boom (2). Bracket 1 1. Pull out the boom foot pin (1) until the end of the pin is flush with the inside end of the right side bracket. 2. Apply a film of grease to pin (1). 3. Lift up boom (2) with a crane. NOTE: Connect a chain block to one side wire rope (3) to ad- just the wire rope length to position the boom easily. M116-07-113 3 2 4 4. Make a mark appointing the outer fringe of the boom foot boss on the inside surface of the boom mounting bracket of the mainframe, so that the boom can be easily installed on the mainframe. WARNING:
• When aligning the center of the pin and pin hole, never put fingers into the pin hole. • When using a hammer, wear safety equipment such as safety glasses or a hard hat to protect against injury from flying pieces of metal. • When inserting the pin, never enter into the area under the boom. 5. Align the boom bottom hole with the boss hole on the frame. Measure clearance “a.” If clearance “a” is 1 mm or more, remove the shim on the pin and install it on the cab side, as illustrated Shim M116-07-036 Pin 6. Push boom foot pin (1) in. (Refrain from driving the pin in with a hammer if possible.
The pin can be easily inserted by hand if alignment, of the pin and pin hole, is correct.) Cab Side 7. Secure boom foot pin (1) with plate (5) and bolts (6). Bolt tightening torque: 400 N•m (40 kgf•m, 290 lbf•ft) Boss of Boom Foot Boss of Frame Side M1J1-06-018 Mark 8. Lower the boom tip to the ground. M116-07-121 5 6 M116-07-030 6-8 Clearance (a)