hitachi — 850.indb

ASSEMBLING INSTALLING BUCKET 1 1. Install the Unit Type O-rings (only Long Arm Spec) around the bucket bosses at the arm connecting section. (In case using Separate Type O-rings, refer to “O-ring Installation Method” in the maintenance.) 2. Start the engine. Raise the arm (2) tip approximately 2.5 m (2.7 yd) above the ground. Arm Bucket Boss 3. Sling bucket (6) with a crane. Align pin (5) hole of the bucket with pin hole (4) of the arm. 3 4 M1J1-06-024 4. While the top of the bucket boss contacts the arm, adjust the clearance between arm and bucket to become from 0.5mm to 1mm (0.02 in to 0.04 in) by Shims.

Refer to the page for “Adjust the Bucket Linkage” in the maintenance section.) 5 2 6 WARNING: • When aligning the centers of the pin and pin hole, never put fingers into the pin hole. • When using a hammer, wear safety equipment such as safety glasses or a hard hat to protect against injury from flying pieces of metal. • While installing the bucket pin, never allow anyone to enter into the area under the bucket. 7 M116-07-038 5. Drive pin (5) into the pin bosses. Secure pin (5) and pin lock stopper (10) with bolt (11). Clearance Adjust Part Tightening torque: 400 N•m (40 kgf•m, 290 lbf•ft) 6.

While extending or retracting the bucket cylinder, align pin hole (3) of the link with that of bucket (6). M503-07-056 7. Drive the pin (7) into the bucket and link. Secure the pin (7) and pin lock stopper (8) with bolt (9). Pin Bucket Tightening torque: 400 N•m (40 kgf•m, 290 lbf•ft) 8. Slide the O-ring onto the boss end gap between the bucket and arm. (Refer to the page for “Change Bucket ” in the maintenance section.) Shim Arm M1JB-07-057 8 9 10 11 M1JB-07-058 6-14