hitachi — 850.indb

ASSEMBLING CONNECTING BUCKET CYLINDER HOSES WARNING: • Stop the engine. Move the control levers back and forth, and right and left several times to release the remaining pressure in the hydraulic line. • Before connecting the bucket cylinder and the pipes on the boom with the hoses, loosen bolts securing the covers to the pipes on the boom to gradually release the trapped oil pressure in the pipings. Then, remove the covers. 1. Gradually loosen bolts securing the covers to the ends of the hydraulic pipings on the boom to release the trapped oil pressure in the pipings. Then, remove the covers. 2. Connect two hoses between the hydraulic pipings on the boom and bucket cylinder. 3.

To prevent seals from damage, bleed the air from the bucket cylinder according to the following procedures. 3.1 Start the engine and run it at slow speed. 3.2 Slowly extend and retract cylinder rod (1). 3.3 Repeat operation in step 2 until cylinder rod (1) moves smoothly. 1 M167-07-018 6-13