hitachi — 850.indb

ASSEMBLING CONNECTING ARM CYLINDER ROD 1. To prevent seals from damage, bleed the air from the arm cylinder according to the following procedures. 1 (1) Start the engine and run it at slow speed. (2) Sling arm cylinder (2) with a crane. Slowly extend and retract rod (1). (3) Repeat operation in step 2 until cylinder rod (1) moves smoothly. 2. Align rod-pin bore (3) of the arm cylinder (2) with pin (4) on the arm by moving the arm cylinder (2) up and down while extending or retracting the cylinder rod. M167-07-017 2 WARNING: • When aligning the centers of the pin and pin hole, never put fingers into the pin hole.

• When using a hammer, wear safety equipment such as safety glasses or a hard hat to protect against injury from flying pieces of metal. • When inserting the pin, never enter into the area under the arm cylinder. 3. After driving the pin into the pin holes, install pin lock plate (5) with bolts (6). 3 4 M1J1-06-022 Tightening torque: 400 N•m (40 kgf•m, 290 lbf•ft) 6 4. When connecting the arm-cylinder-rod greasing hose to the arm cylinder rod, install adaptor (7) with angle (A) of 10 to 30° so that the hose does not come into contact with the arm cylinder mounting bracket. 5 M1J1-06-020 7 A M1J1-06-023 6-12