MAINTENANCE PERIODIC REPLACEMENT OF PARTS To ensure safe operation, be sure to conduct periodic inspec- tion of the machine. In addition, the parts listed below, if de- fective, may pose serious safety/fire hazards. It is very difficult to gauge the extent of deterioration, fatigue, or weakening of the parts listed below simply by visual inspection alone. For this reason, replace these parts at the intervals shown in the table below. However, if any of these parts are found to be defective, replace before starting operation, regardless of the interval. Also, when replacing hoses, check the clamps for deformation, cracks, or other deterioration, and replace as necessary.
Be sure to perform periodic inspection of all hoses, as shown below, and replace or retighten any defective parts found, as necessary. Consult your authorized dealer for correct replacement. NOTE: Be sure to replace seals, such as O-rings and gaskets, when replacing hoses.
7-5 Periodic Replacement Parts Replacement Intervals Engine Fuel hose (Fuel tank to filter) Every 2 years or Every 6000 hours Fuel hose (Fuel tank to injection pump) Every 2 years or Every 6000 hours Heater hose (Heater to engine) Every 2 years or Every 6000 hours Hydraulic System Base Machine Pump suction hose Every 2 years or Every 6000 hours Pump delivery hose Every 2 years or Every 6000 hours Swing hose Every 2 years or Every 6000 hours Travel hose Every 2 years or Every 6000 hours Front-End Attachment Boom cylinder line hose Every 2 years or Every 6000 hours Arm cylinder line hose Every 2 years or Every 6000 hours Bucket cylinder line hose Every 2 years or Every 6000 hours Pilot hose Every 2 years or Every 6000 hours Other Seat belt Every 3 years