Freightliner Business Class — Business Class Driver's Manual

Transmissions These transmissions are designed for use with on- highway, fuel economy engines, where a minimum of shifting is desired and less gear reduction is acceptable. Continue downshifting, as conditions require, using the same sequence described above. Operation, Straight-Shift NOTE: With synchronized models (five-speed and six-speed) disengage the clutch completely when shifting gears. Double clutching is unnecessary. With nonsynchronized models (seven-speed) al- ways double-clutch when shifting gears. If the ve- hicle is moving when shifting, depress the clutch pedal just far enough to disengage the clutch.

De- pressing it to the floor will engage the clutch brake, if so equipped, causing premature clutch brake wear. 1. Always use 1st gear when starting to move the ve- hicle forward. 2. Accelerate to engine governed speed. Disengage the clutch and move the shift lever to 2nd gear; double-clutch with the seven-speed models. En- gage the clutch and accelerate to engine governed speed. IMPORTANT: Do not rest your foot on the clutch pedal while driving. This causes partial clutch dis- engagement, which could cause premature clutch wear. Eaton Fuller Range-Shift Transmissions 3. Continue upshifting using the same sequence de- scribed in step 2 above. Follow the pattern on the shift lever.

Refer to the Eaton web site for additional information, www.roadranger.com. A connection to the Internet is required. 4. When downshifting, shift progressively down through each successive lower gear as follows: General Information, Eaton Range- Shift When the engine speed drops to the same rpm to which it fell immediately after upshifting to that same gear, disengage the clutch and move the shift lever to the next lower gear. Engage the clutch smoothly. IMPORTANT: These are nonsynchronized trans- missions. Always double-clutch when shifting 5.2