Freightliner Business Class — Business Class Driver's Manual

Transmissions 4. Do not preselect with the splitter control button; af- ter moving the control button, complete the shift immediately. 5. Shift upward from Low to 1st gear, 2nd, etc. until 4th gear, double-clutching between shifts, and ac- celerating to 80 percent of engine governed speed. 5. Except when downshifting from 5th direct to 4th gear, never push the range preselection lever down into LO range while operating in HI range—the splitter will become inoperative. 6. When in 4th gear and ready to shift up to 5th gear, use the range shift lever as follows: 6.1 While in 4th gear, pull the range shift prese- lection lever up, into HI range.

Upshifting 6.2 Disengage the clutch and double-clutch through neutral. The transmission will auto- matically shift from LO to HI range as the shift lever passes through neutral. 1. Position the gear shift lever in neutral. Start the en- gine, and bring the air system pressure within 95 to 125 psi (655 to 862 kPa). 6.3 Move the shift lever to 5th gear. 2. Make sure the range preselection lever is down (in LO range). 6.4 Engage the clutch and accelerate the en- gine. 3. Make sure the splitter control button is in the direct (aft) position. 4. Start the vehicle. 7. Shift up through the HI range gears as follows:

7.1 To shift from 5th direct to 5th overdrive, move the splitter control button into the over- drive (forward) position, then immediately release the accelerator. Press and release the clutch pedal. After releasing the clutch, accelerate again. 4.1 Press the clutch to the floor. 4.2 Shift into Low or 1st gear. 4.3 Release the clutch, with the engine at or near idle speed, to start the vehicle moving. 4.4 Accelerate to 80 percent of engine governed speed. 7.2 Continue upshifting through the shift pattern. Double-clutch during lever shifts (6th to 7th to 8th); single-clutch during split shifts (6th direct to 6th overdrive, etc.). 5.8