Transmissions Downshifting Operation, Deep-Reduction Models Upshifting 1. Downshift from 8th overdrive to 8th direct without moving the shift lever. 1. Position the gear shift lever in neutral. See Fig. 5.8 for the shift pattern. Start the engine, and bring the air system pressure up to 95 to 125 psi (655 to 862 kPa). 1.1 Move the splitter control button to the direct (aft) position. Immediately release the accel- erator, and disengage the clutch. 1.2 Engage the clutch, and accelerate the en- gine only after the transmission has shifted. 2. Position the range preselection lever down, into low range. 2. Downshift from 8th direct to 7th overdrive. NOTE:
If conditions are difficult, start out in LO- LO. Move the deep reduction lever on the dash- board to the IN position. Otherwise start out in LO with the deep reduction lever in the OUT position. 2.1 Start the downshift by moving the splitter control button to the overdrive (forward) po- sition. 2.2 Immediately double-clutch through neutral, moving the shift lever from 8th to 7th gear 3. Depress the clutch pedal to the floor. Shift into LO gear; then, engage the clutch, with the engine at or near idle rpm to start the vehicle moving. The ve- hicle will start in LO or LO-LO depending on the deep reduction lever position. 3.
Shift downward through each of the HI range gears, alternating the procedures in steps 1 and 2, above, until reaching 5th direct. 4. To upshift if in LO-LO, move the deep reduction lever to the OUT position and immediately release the accelerator, depress the clutch pedal once to break torque, and reengage the clutch. The auxil- iary section will shift from LO-LO to LO when the gears reach the same speed. 4. While in 5th direct and ready for the downshift to 4th, push the range preselection lever down. Then, double-clutch through neutral and move the shift lever to the 4th gear position. 5. Continue downshifting from 4th to 1st as conditions require. 5.9