Transmissions of the 10 speed ratios are shifted with the shift lever and the other half are shifted by moving the shift button. B There are three types of shifts used with the Super 10 transmission. The button-only shift is a gear range shift that occurs by moving the shift button (see Fig. 5.9 ). The lever-only shift occurs when the shift lever is moved without moving the shift button. The combination button/lever shift is a gear ratio change that occurs by moving both the shift button and the shift lever. Button- only and combination button/lever shifts are both full gear changes and the lever-only shift skips a gear. See Fig. 5.10 for the shift patterns.
Fuller A Fuller 09/25/96 f260399 C Top-2 (T2) transmissions are equipped with an optional feature that allows the transmission to automatically shift between the top two gears (9th-10th) without the need for button shifts. A. Shift Button B. Gears 2, 4, 6, 8, 10 when button is forward C. Gears 1, 3, 5, 7, 9 when button is rearward 2. Use the clutch brake to stop gear rotation when shifting into 1st or reverse when the vehicle is sta- tionary. The clutch brake is actuated by depressing the clutch pedal all the way to the floor. Fig. 5.9, Super 10 Shift Knob Operation, Super 10 1.
When operating off-highway, or under adverse con- ditions, always use low gear (if so equipped) when starting to move the vehicle. For normal upshifts and downshifts, only a partial disengagement of the clutch is necessary to break engine torque. When operating on-highway, with no load, or under ideal conditions, use 1st gear when starting to move the vehicle. 3. Do not make range shifts with the vehicle moving in reverse gear. For all conditions, use the highest gear that is still low enough to start the vehicle moving with engine idling, and without slipping the clutch excessively. 5.11