Transmissions HI LO R R 4 3 8 7 CAUTION Failure to keep the transmission in gear at all times with the vehicle in motion could lead to transmis- sion damage. N 1 2 6 5 10 9 7. Avoid hunting for neutral by moving the gear shift lever from the left rail to right rail. This action can cause excessive transmission wear. 09/24/96 f260397 Upshifting Fig. 5.10, Super 10 Transmission Shift Pattern 1. Position the gear shift lever in neutral. Start the en- gine, and bring the air system pressure up to 100 to 120 psi (689 to 827 kPa). 4. The shift lever should not be moved to the center or left rail positions at vehicle speeds above 40 mph (65 km/h). 2. Depress the clutch pedal to the floor.
Shift into 1st gear, then engage the clutch, with the engine at or near idle speed, to start the vehicle moving. 5. Use double-clutching between all upshifts and downshifts. 3. Button shift—Preselect the next gear by sliding the shift button forward. Break torque by releasing the throttle or by depressing the clutch pedal. Decrease engine speed to synchronize the engine speed with the transmission speed. The shift will complete when the engine rpm has decreased to the proper speed. The button only shift is used for gear changes from 1st to 2nd, 3rd to 4th, 5th to 6th, 7th to 8th, and 9th to 10th. 6. After your shifting ability improves, you may want to skip some of the ratios.
This may be done only when operating conditions permit, depending on the load, grade, and road speed. 5.12