Freightliner Business Class — Business Class Driver's Manual

Transmissions current gear position stops flashing, and engine rpm increases and becomes steady. IMPORTANT: If you have to leave the cab with the engine running: NOTE: If the shift is missed, control engine speed in the direction indicated by the arrows on the dis- play to synchronize engine rpm with the transmis- sion’s speed. Place the transmission in neutral. Set the parking brakes. Chock the tires. Push-Button Shift Selector Eaton Fuller AutoShift Gear information is presented to the driver on the push- button shift selector, usually mounted on the right-hand control panel. On this display, the information is pre- sented as follows:

Refer to the Eaton web site for additional information, www.roadranger.com. A connection to the Internet is required. IMPORTANT: Before starting the vehicle, always do the following: To select neutral, press the N button. When neu- tral is engaged, the telltale LED will light up next to the N button. Be seated in the driver’s seat. Place the transmission in neutral. To select reverse, press the R button. When re- verse is engaged, the telltale LED will light up next to the R button. Set the parking brakes. Press the clutch pedal down to the floor. To select drive, press the D button. When drive is engaged, the telltale LED will light up next to the D button.

The AutoShift AS2 is a partially automated 10-speed or 18-speed Eaton Fuller transmission. The AutoShift ASX is a partially automated 6-speed or 7-speed Eaton Fuller transmission. For all, the driver must use the clutch and put the transmission in neutral to start and stop the vehicle. A push-button shift selector ( Fig. 5.13 ) is used with AutoShift transmissions. To select low gear, press the LOW button. When low is engaged, the telltale LED will light up next to the LOW button. To change gears manually, press the MANUAL button. When the manual mode is engaged, the 5.18