Transmissions Shift Solenoid The solenoids select the optimum oil path of the valve body in the transmission based on ECU signals to con- trol gear change and lockup operation. R N D 2 L 3 Oil Temperature Switch When the transmission oil temperature rises abnormally, the oil temperature switch activates to light the oil tem- perature warning lamp on the driver’s instrument panel. 08/09/2000 f261083 Fig. 5.21, Column Shift Indicator Window Power Selector Switch If the operator selects range 3 while the vehicle is cur- rently in fourth or fifth gear, the transmission will posi- tion for a shift to third gear. The power selector switch includes two modes: power and economy.
Drivers can select a running mode by depressing the power selector switch. This switch trans- mits information to the ECU gear shift and lockup timing signals appropriate for each running mode. During low-speed operation, the gear position is directly shifted to third gear. During high-speed running, the transmission will posi- tion for a downshift to the next available lower gear until the speed is sufficiently reduced to prevent overrun of the engine and the transmission can safely shift into third gear. Over Drive (O/D) The O/D switch controls O/D status. Gear shift to fifth is prevented when O/D is switched off.
Range Selections Range 2 The following information explains how the transmission range selections function when selected. See Fig. 5.21 . When the operator selects range 2, the transmission will only shift between first and second gears. If the op- erator selects range 2 while the vehicle is currently in third, fourth or fifth gear, the transmission will position for a shift to second gear. Range 3 When the operator selects range 3, the transmission will only shift between first, second, and third gears. 5.40