Clutches, Rear Axles, and Steering Clutches Eaton Valeo Clutch Break-In General Information The major reason clutches wear out too soon is exces- sive heat. Clutches are designed to absorb and dissi- pate more heat than encountered in typical operation. The temperatures developed in typical operation will not break down the clutch friction surfaces. However, if a clutch is slipped excessively, or required to do the job of a fluid coupling, high temperatures develop quickly and destroy the clutch. Temperatures generated between the flywheel, driven discs, and pressure plates can be high enough to cause the metal to flow and the friction facing material to char and burn.
With a new or newly installed Eaton Valeo clutch, the clutch may slip for a short time while the friction sur- faces break-in. However, allowing the clutch to slip for more than two seconds can severely damage the clutch disc, pressure plate, and the flywheel. During initial operation of a new vehicle or a vehicle with a new clutch, check for clutch slippage during ac- celeration. If the clutch slips, decelerate until the clutch does not slip. Allow the clutch to cool 15 to 30 seconds, and then gradually accelerate again. If the clutch contin- ues to slip, repeat the procedure. If necessary, repeat the procedure up to five times. If the clutch slips after five attempts, stop the vehicle.
Allow the clutch to cool for at least one hour. Notify your Freightliner dealer of the problem. Slipping and excessive heat are practically nonexistent when a clutch is fully engaged. But during the moment of engagement, when the clutch is picking up the load, it generates considerable heat. An incorrectly adjusted or slipping clutch will rapidly generate sufficient heat to destroy itself. CAUTION The most important items that a driver should be aware of to ensure long service life of the clutch include: start- ing in the right gear, recognizing clutch malfunctions, and knowing when to adjust a clutch. Do not allow sustained slippage of the clutch.
This could severely damage the clutch disc, pressure plate, or flywheel. Damage caused by clutch slip- page due to improper break in is not warrantable. 6.1