Clutches, Rear Axles, and Steering Clutch Operation Starting the Vehicle in the Correct Gear mission still in gear, a reverse load will be put on the gear. At the same time, it will have the effect of trying to stop or decelerate the vehicle with the clutch brake. Rapid wear of friction discs will take place necessitating frequent replacement. Consider- able heat will be generated, which will be detrimen- tal to the release bearings and transmission front bearings. To drive forward, always start in first gear. After the clutch is fully engaged, the engine should be acceler- ated to the correct rpm for the upshift into the next higher gear.
Gear Shifting Techniques Many drivers upshift into the next gear, or even skip- shift into a higher gear, before the vehicle has reached the correct speed. This type of shifting is almost as bad as starting off in a gear that is too high, since the en- gine rpm and vehicle speeds are too far apart, requiring the clutch to absorb the speed difference by generating heat. For transmission operating instructions, see Chapter 5 . Vehicle Overload, or Overloading the Clutch Clutches are designed for specific vehicle applications and loads. These limitations should not be exceeded. CAUTION Overloading will not only result in damage to the clutch, but also to the entire power train.
The clutch brake (if equipped) is applied by fully de- pressing the clutch pedal. Its purpose is to stop the transmission gears from rotating in order to engage the transmission gears quickly in making an initial start. Riding the Clutch Pedal Riding the clutch pedal is destructive to the clutch, since partial clutch engagement permits slippage, gen- erating excessive heat. Riding the clutch pedal will also put a constant thrust load on the release bearing, which can thin out the lubricant. Release bearing failures can be attributed to this type of misuse. CAUTION Never apply the clutch brake when making down- shifts or upshifts.
The clutch pedal should never be fully depressed before the transmission is put in neutral. If the clutch brake is applied with the trans- 6.2