Clutches, Rear Axles, and Steering Eaton Single Reduction Axles with Controlled Traction Differential A The controlled traction differential system is a differen- tial assembly incorporating a friction plate assembly de- signed to transfer torque from the slipping wheel to the one with traction. The unit is basically a multiple disc clutch designed to slip above predetermined torque val- ues. This controlled slipping characteristic at higher torque values enables the vehicle to negotiate turns in a normal manner. Resistance to slippage at lower torque values enables the vehicle to maintain an appreciable amount of tractive effort when one wheel encounters relatively poor traction.
B 02/09/96 f350079a A. Turning Radius When Differential is Locked (engaged)—Understeer Condition B. Turning Radius When Differential is Unlocked (disengaged) A control valve in the cab is actuated by the driver to engage and disengage the controlled traction feature. To unlock the main differential, depress the bottom of the control switch. Briefly let up on the accelerator to relieve torque on the gearing, allowing the differential to fully unlock. Fig. 6.3, Turning Radius Disengaged, the axle has differential action all the time. One wheel will spin independently of the other, if slip- pery conditions are encountered. Engaged, wheel slippage and spinout are minimized. NOTE:
The controlled traction differential can be engaged at any speed, except during spinout. When the differential lock disengages, the indicator light will go off. Eaton Two-Speed Tandem Axles Each axle of the two-speed tandem contains a high range single reduction gear set and a low range double reduction gear set. The operator selects the desired 6.7