Freightliner Business Class — Business Class Driver's Manual

Brakes the knob applies both the tractor and the trailer spring parking brakes, and automatically causes the trailer air supply valve knob to pop out. air hoses are connected to a trailer, and the pressure in both air systems is at least 65 psi (448 kPa), the red knob must be pushed in. It should stay in to charge the trailer air supply system and to release the trailer spring parking brakes; it must be pulled out before disconnect- ing a trailer. It must also be pulled out when operating a vehicle without a trailer.

If pressure in both air systems drops to 35 to 45 psi (241 to 310 kPa), the red knob automatically pops out, exhausting the trailer air supply and applying the trailer service or spring parking brakes. 1 CAUTION 2 Don’t use the spring parking brakes if the service brakes are hot, such as after descending a steep grade. Also, don’t use the spring parking brakes during freezing temperatures if the service brakes are wet. To do so could damage the brakes if hot or, cause them to freeze during cold weather. 1. Parking Brake Control Valve Knob 2. Trailer Air Supply Valve Knob f600372 If the brakes are wet, drive the vehicle in low gear and lightly apply the brakes to heat and dry them.

Allow hot brakes to cool before using the spring parking brakes. Fig. 7.1, Parking Brake Control Valve and Trailer Air Supply Valve Knobs (typical location) If the trailer is not equipped with spring parking brakes, pulling out the yellow knob applies the tractor spring parking brakes and the trailer service brakes. When the tractor and trailer parking brakes (or trailer service The red octagonal knob ( Fig. 7.1 ) on the control panel actuates the trailer air supply valve. After the vehicle’s 7.3