Fifth Wheels 3. Chock the front and rear of the trailer tires to pre- vent the trailer from moving. Fontaine Fifth Wheels General Information WARNING On Fontaine fifth wheels, kingpin release is accom- plished by activating a manual lock control handle lo- cated on the left or right side of the fifth wheel. Kingpin lockup occurs when the kingpin is forced into the jaws and the lock control handle moves to the locked posi- tion. Do not use the trailer air supply for parking trailers not equipped with spring parking brakes. This ap- plies the trailer service brakes only. As air bleeds from the trailer brake system, brake application is lost.
This could allow the unattended vehicle to roll away, possibly resulting in serious personal injury or death. On stationary fifth wheels, the fifth wheel top plate is bracket-mounted to the tractor frame in a position that best distributes the trailer load over the tractor axles. 4. Lower the trailer landing gear until the weight is re- moved from the fifth wheel. The sliding fifth wheel mount is used with the Fontaine H5092 series, and the Fontaine 6000/7000 No-Slack II series fifth wheels, and is equipped a with either an air- operated release slide (HAWB or AWB model), or a manual release slide (HMWS or MWS model).
The fifth wheel top plate is mounted on a slide assembly, which is attached to slide rails that are mounted on the vehicle frame. The slide rails permit forward and rearward movement of the slide assembly, allowing for optimum weight distribution over the tractor axles. 5. Disconnect the tractor-to-trailer air system lines and electrical cable. Plug the air lines to prevent dirt or foreign material from entering the lines. 6. Release the kingpin locking mechanism by pulling the kingpin lock control handle ( Fig. 8.1 ) to the out- ward position. 7. Slowly drive the tractor away from the trailer.
Slots are evenly spaced along the slide rails, and re- tractable tapered wedges are positioned through the slots to hold the fifth wheel in the desired position. See Fig. 8.5 or Fig. 8.6 . 8.6