Pretrip Inspection and Daily Maintenance 8. Check the condition of the coolant hoses and heater hoses. Check all of the belts for proper tension. Use your index finger to apply approximately 25 pounds (11 kg) of force at the center of the belt free-span. See Fig. 9.4 . Deflection should be one belt thickness per 1 foot (300 mm) of belt free-span. If the tension is more than or less than this value, measure it with a belt-tension gauge and adjust it to the proper ten- sion. See Group 01 of the Business Class ® Trucks Service Manual for instructions. Make sure that the radiator inlet and outlet coolant hoses and heater hoses are pliable and are not cracking or ballooning.
Replace hoses that show signs of cracking, weakening, or ballooning. Re- place all hoses, including heater hoses, at the same time. Service-type knitted or braided yarn- reinforced neoprene hose is acceptable. Silicone hoses, having an extended service life, can be substituted for the reinforced neoprene type. See the Service Parts Catalog or contact your Freightliner Dealer. Tighten hose clamps as necessary, but do not over- tighten as hose life can be adversely affected. A B Be sure that the hose support brackets are securely fastened. Make sure that the hoses are not located near sources of wear, abrasion, or high heat. 10/31/94 f200036a 9. Check the condition of the drive belts.
Check the fan belt(s), alternator belt, and refrigerant compressor belt for signs of glazing, wear (frayed edges), damage (breaks or cracks), or oil contami- nation. If a belt is glazed, worn, damaged, or oil soaked, replace the belt following the instructions in Group 01 of the Business Class ® Trucks Service Manual. A. Deflection B. Belt Free-Span Fig. 9.4, Checking Belt Tension NOTE: On Cummins engines, a belt tensioner au- tomatically adjusts the fan and alternator belt to 9.8