Freightliner Business Class — Business Class Driver's Manual

Pretrip Inspection and Daily Maintenance the correct tension. If the belt slips, repair or re- place the tensioner. For instructions, see the Cum- mins Shop Manual B Series Engines. CAUTION Failure to maintain a sealed air intake system could allow the entry of contaminants into the engine. This could adversely affect engine performance and result in engine damage. 10. Inspect the engine for fuel, oil, and coolant leaks. Correct any leaks found. 11. Inspect the engine and chassis wiring. NOTE: After replacing the filter element, reset the restriction indicator by pressing the reset button.

Inspect the engine and chassis for loose wiring, chafed insulation, and damaged or loose hold-down clamps. Tighten loose wires or hold-down clamps; replace damaged wiring or clamps. 13. Check the fluid level in the hydraulic brake fluid res- ervoir ( Fig. 9.5 ) if equipped. 12. Check the air intake system for leaks or damage. If needed, fill the reservoir to the flange that sur- rounds the reservoir. Use only heavy-duty brake fluid, DOT 3. Check the intake-air restriction indicator to deter- mine if the air cleaner filter element needs to be changed. Replace the filter element if the yellow signal stays locked at 25 inH 2 O for Cummins en- gines or 20 inH 2 O for Mercedes-Benz engines.

See Group 09 of the Business Class ® Trucks Service Manual for filter element replacement instructions. 14. Check the fluid level in the clutch fluid reservoir ( Fig. 9.6 ). The reservoir is full when the fluid level is at the MAX mark. The fluid level must always be above the MIN mark. Use only heavy-duty brake fluid, DOT 3, in the hydraulic-clutch system. Check the engine air intake piping from the air cleaner to the engine intake. Inspect the piping for loose connections, cracks, torn or collapsed hoses, punctures, and other damage. Tighten loose con- nections and replace damaged components.

Make sure that the piping system is airtight so that all of the intake air passes through the air cleaner. 15. Check the engine oil level ( Fig. 9.7 ). The oil level should show between the upper and lower marks on the dipstick. Add enough oil to bring the level up to the operating range. See the engine 9.9