Pretrip Inspection and Daily Maintenance ring seating, and possible wheel, rim, or tire damage before adding air. Variations in Load and Inflation Limits According to Speed Percent Increase/ Decrease in Load 70 to 75 (113 to 121) 10 (69) 61 to 70 (98 to 113) 10 (69) 0 51 to 60 (82 to 97) 0 0 41 to 50 (66 to 80) 0 +9 31 to 40 (50 to 64) 0 +16 21 to 30 (34 to 48) 10 (69) +24 11 to 20 (18 to 32) 15 (103) +32 Speed Range mph (km/h) Inflation Pressure Increase in psi (kPa) 43.3 Moisture inside a tire can result in body ply separation or a sidewall rupture. During tire inflation, compressed air reservoirs and lines must be kept dry.
Use well-maintained inline moisture traps and service them regularly. 43.4 Inspect the tires for bulges, cracks, cuts, or penetrations. A tire pressure check will assist in uncovering hidden damage. A weekly pressure loss of 4 psi (28 kPa) or more in a tire may indicate damage and the tire should be inspected and repaired or replaced. 43.5 Tires should also be inspected for oil con- tamination. Fuel oil, gasoline, and other pe- troleum derivatives, if allowed to contact the tires, will soften the rubber and destroy the tire. Table 9.3, Variations in Load and Inflation Limits According to Speed WARNING Do not operate the vehicle with underinflated or overinflated tires.
Incorrect inflation can stress the tires and make the tires and rims more susceptible to damage, possibly leading to rim or tire failure and loss of vehicle control, resulting in serious per- sonal injury or death. 43.6 If the tires are wearing irregularly, rotate them. If the front steering axle tires become irregularly worn, move them to the drive axle ( Fig. 9.15 ). Have the front axle alignment checked to determine the cause of irregular tire wear. In a dual assembly, if one tire wears faster than its mate, reverse the posi- tion of the two tires. See Fig. 9.16 . 43.2 If a tire has been run flat or underinflated, check the wheel for proper lockring and side 9.30