In an Emergency Hazard Warning Lights Towing The hazard warning light tab ( Fig. 11.1 ) is located on the turn signal control lever. To operate the hazard lights, pull the tab out. All of the turn signal lights and both of the indicator lights on the control panel will flash. WARNING Do not tow unbraked vehicles if the combined weight of both vehicles is more than the sum of the gross axle weight ratings (GAWRs) of the towing vehicle. Otherwise brake capacity will be inad- equate, which could result in personal injury or death. IMPORTANT: When it is necessary to tow the ve- hicle, make sure the instructions below are closely followed to prevent damage to the vehicle.
To cancel the hazard warning lights, push the turn sig- nal control lever either up or down, then return the lever to its neutral position. Front Towing Hookup 1. Disconnect the battery ground cable. 1 2. If the vehicle is to be lifted and towed, remove the drive axle shafts. 10/21/93 f460511 CAUTION 1. Hazard Warning Light Tab Failure to remove the axle shafts when towing the vehicle with the rear wheels on the ground could result in damage to the transmission and other parts. Fig. 11.1, Hazard Warning Light 11.1