Freightliner Business Class — Business Class Driver's Manual

In an Emergency 3. Cover the ends of the hubs with metal plates or plywood cut to fit the axle opening, and drilled to fit the axle shaft studs. This prevents lubricant from leaking out, and will keep contaminants from getting into the axle lubricant and damaging the wheel bearings. ardous conditions because the vehicle could sud- denly roll and injury could occur. 9. Release the parking brakes. Rear Towing Hookup 4. Remove the bumper extension and chrome bumper, if installed. CAUTION 5. Attach the towing device.

Due to the many vari- ables that exist in towing, positioning the lifting and towing device is the sole responsibility of the towing-vehicle operator, who must be familiar with standard towing industry safety measures. Using a rear towing hookup on a vehicle equipped with a roof fairing could cause damage to the cab structure. IMPORTANT: Because of the possibility of exces- sive wind force which could cause damage to the cab, do not use a rear towing hookup on any ve- hicle equipped with a roof fairing. 6. Lift the vehicle, and secure the safety towing chains. If additional clearance is needed, remove the front wheels. 7. Connect the clearance lights, taillights, and signal lights.

Connect any special towing lights required by local regulations. 1. Place the front tires straight forward, and secure the steering wheel in this position. 2. Disconnect the battery ground cable. 8. If equipped with air brakes, connect the towing ve- hicle’s air brake system to the vehicle being towed. 3. Attach the towing device. Due to the many vari- ables that exist in towing, positioning the lifting and towing device is the sole responsibility of the towing-vehicle operator, who must be familiar with standard towing industry safety measures. WARNING Before releasing the parking brakes, make the con- nection to the towing vehicle, or chock the disabled vehicle’s tires.

Failure to do so could result in haz- 11.2