Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING engine is stopped and may cause serious burns. Wait for the oil 3 - 76 CHECK BEFORE Always check the it ems in this section b efore starting the engine Parts and oil are at h igh temperature i mmediately after the temperature to go dow n before performing th is operation . 1. Open the engin e side cover on the l eft side of t he chassis 2. Remove dipstic k (G), and wipe the o il off with a cloth. 3. Fully insert dips tick (G) into fille r pipe (F), then remov 4. The oil level sho uld be between the H and L marks on dipstick ( I f G). f the oil level is iller (F). below the L mark, add engine oil through oil 5.

I f the oil is adov e the H mark, drain t he excess engine oil f rom drain plug (1), a nd check the oil leve l again. 6. I f the oil level is correct, tighten ca close the engin REMARK When checking the oil level after the engine ha s been operated, wait for at least 15 mi nutes after stopping the engine before ch ecking. at an angle make it horizontal before checking. , remove the dipstick form the holder to release the air inside the crankcase. If the machine is at an angle make it horizontal before checking. When adding oil , remove the dipstick form the h older t o release the air inside the crank